
18 miniVEOS Installation Guide
If your vendor has installed the miniVEOS system software, skip this section and
proceed to Configuring miniVEOS on page 21.
To install the miniVEOS system software, configure miniVEOS to boot from the
included miniVEOS system software CD-ROM in an external USB optical drive.
Once the system software installer loads up, type miniVEOS and press Enter
to start the installation.
The following hardware should be connected to miniVEOS before it is powered
up for installation:
A display capable of at least 1024x768 resolution, connected to the
VGA/DVI port
USB keyboard
USB mouse
Once the display, keyboard and mouse are connected, miniVEOS can be
powered on.
Booting the miniVEOS System CD-ROM
When miniVEOS is starting up, press the key indicated on the screen to enter the
BIOS setup. This is usually the Delete key.
Comentarios a estos manuales